![]() ![]() In your first post I understood that the VMs could not see the traffic if on another host.Īny VM on that new host can capture all the traffic from all other VM's in that subnet regardless of the host" then it is doing what you need right? Port Mirroring should have nothing to do with that. Any VM on that new host can capture all the traffic from all other VM's in that subnet regardless of the host. I can vMotion the PFSense VM to another host and it's the same thing. I'm still wondering why any VM (with a DHCP address from the PFSense) that's on the same host as the PFSense can capture traffic from all other VM's on that subnet regardless of what host the other VM's are on. I'm trying to capture traffic between all VM's that have a DHCP address from the PFSense. you could source the vlan or juts the pfsense port-group, the desitnaiotn will be a new distributed port for your VMs. Using 3 VMs is an added challenge - you might need 3 port mirrors. You do not mention a port mirror - a port mirror is required to soruce the traffic and copy it to the destination (in your case the 3 VMs). You actually state your objective - is it to packet capture all traffic from the LAN to the pfsense? or WAN to pfsense? both? I read that in order to configure a USB device on an Oracle VM the procedure is. Hi Guy, the only adapter I'm using on Ubuntu VM is the D-Link wireless N nano USB adapter (8192eu). Sorry for the confusion, you are right: I installed Oracle Virtualbox on Windows 10 and I have Ubuntu distro as VM. That's why I moved to the iwconfig command instead. I don't have the prompt back and I have to close the monitor window. Hi Bob, yes I've tried to use airmon-ng start "wlan0", and I don't know how, but this command hangs forever. Thanks again for any suggenstion you may give me. My question is: is there a way in which I can tell wireshark the channel on which doing the sniffing ? (So far I just saw channel 1 or 11, never seen channel 6). ![]() It seems that the actual channel selection (the one shown in the radio information section) is done randomly. But I've noticed, looking into the IEEE802.11 radio information section, that the channel is not always 1: sometimes it it 11 and when this happens I get many more records in my sniffing file. I check that the interface is in monitor mode by running iwconfig.Īt this point I run wireshark (on the guest) it works, but I can not specify the channel on which to do the sniffing (the display always says "channel 1"). here I usually get an error, but as found on the chat I have to ifconfig "wlano0" up and then retry all the commands until they are OK. ![]() Then I have to enable monitor mode, following the following procedure (for simplicity "wlan0" stands for the name of my interface): So I confirm that the WiFi adapter is connected to the guest machine. I installed it taking the drivers from the repository kelebek333/kablosuz (I got his info by looking at other chats on the topic). To do this sniffing I was told to buy the D-Link wireless N nano USB adapter and to configure it on Ubuntu. The purpose of this exercise is to sniffer in monitor mode on wifi 802.11 the behavior of different smartphones, specifically how they send the "Probe Request" messages according to various conditions (display active/inactive, wifi connected/non connected, power save on/off). I've installed Wireshark on Ubuntu from the repository wireshark-dev/stable. On top of it I've installed Oracle VM 7.0. The host system is a PC running Windows 10. Thanks Bob and Guy to try helping me! Here are the additional info requested: My purpose os to be able to change the monitored channel in Monitor Mode, because I see that it changes from capture to capture. I'm running Linux 18.04 on virtual machine with Oracle VM. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |